Description
T30... continuous magnetic immersible probes are used for quasi-acquisition of the filling level in containers with liquid media.
Technical Data
Properties TK-300
- connection
- Polyesterdose | Aluminiumdose | Stecker nach DIN 43650
- Protection class socket / plug
- IP 65
- Protection class EN60529 cable
- IP 55
- Float type
- 10 (14)
- connection cable
- 1000 mm LiYY 0,5 mm² oder Silikon 0,5 mm²
- Sliding tube length
- max. 6000 mm
- Operating pressure
- max. 6 bar
- Resolution
- 10 mm, 15 mm oder 1%, 2%, 5% je nach Auflösung
- CE marking
- siehe Konformitätserklärung
Operating temperature
- PV
- max. 60°C
- PE
- max 80 °C
- PP
- max. 90°C
MaterialDensity
- Type 10
- 0,72 g/cm³
- Type 14
- 0,72 g/cm³
- Type 18
- 0,82 g/cm³
TK-300 configuration
| TK300 | 1 | - | 2 | - | 3 | - | 4 | - | 5 | - | 6 | - | 7 | - | 8 |
Further product information
The materials used are PVC, PE, PPH, PTFE, brass or stainless steel (1.4571), depending on the requirements. This makes the magnetic immersion probes suitable for use with highly aggressive media. A ring magnet is built into the float sliding on the guide tube, which switches the reed contacts built into the guide tube with its magnetic field. These reed contacts pick up a partial resistance, which is proportional to the level, from a resistor chain, which is made up of individual resistors. Due to the technology used, the pick-up is quasi-continuous. The contacts are hermetically sealed gas-shielded contacts mounted on a printed circuit board inside the guide tube. The resolution can be adapted to the requirements due to the possible pitches of 7.5/10/15/20 mm or 1%/2%/5%.
Resolution of the measurement can be determined by the choice of the grid. The respective measurement can thus be optimally adapted to the conditions. Subsequent addition of limit values possible
Documents and Downloads
Mounting and installation instructions
test certificate
Video of the product
Accessoires
TK-101
go to product
